1. Turn off the main water valve to prevent leakage during installation. Clean the installation hole on the sink or countop, ensuring the surface is dry and free of debris.
2. Pass the installation screws through the bottom of the faucet base, and then add the rubber gasket and washer in order to ensure a good seal. Lift the faucet and pass the installation screws through the installation hole from above the countertop.
3. Tighten installation nuts under the countertop until the faucet is secure and does not wobble, taking care not to overtighten and damage the imitation base.
4. the cold and hot water supply pipes to the corresponding inlet ports at the bottom of the faucet, and gently tighten them with a wrench to ensure a secure connection without excessive force. the other end of the supply pipes to the cold and hot water supply angle valves under the sink.
5. Slowly open the main water valve and check if there is any at all connection points. If any leakage is found, you can tighten the corresponding interface appropriately until the seepage stops.6. Rotate the high-throw water nozzle confirm that it can rotate smoothly 360° without any obstructions. Use the side-mounted handle to adjust the water temperature and flow rate, ensuring that the faucet normally and the water flow is stable. Wipe the surface of the faucet with a soft cloth to remove any fingerprints or stains left during installation.
1. It is recommended to use the appropriate tools such as wrenches and screwdrivers to avoid using sharp hard tools that may scratch the surface of the faucet, including the plating and imitation jade parts. Before installation, please confirm that the water supply pressure is within the of 0.1–0.5MPa. If the water pressure is too high, a pressure relief valve must be installed. If it is too low, a pressure valve must be installed to avoid affecting the stability of the water flow or damaging the valve core. After unpacking, please check if all accessories are complete and if there is any to the parts during transportation. If there are any problems, please contact customer service immediately.
2. When tightening the installation nuts and water inlet pipe interfaces, moderate force is sufficient Over-tightening may cause the threads to slip, the imitation jade base to crack, or the metal parts to deform. The rubber gasket must be correctly placed between base and the countertop to avoid misalignment leading to leakage. Do not apply glue to the gasket, as this may affect the sealing effect or subsequent disassembly. When the water inlet pipe, ensure that the pipe is not twisted or squeezed to avoid long-term stress causing the pipe to crack and leak. During installation, please wrap the faucet with a soft cloth to avoid tools knocking against the plating surface and imitation jade parts, causing scratches or damage.
3. When adjusting the handle, please push it to avoid violent twisting or frequent switching between cold and hot positions, which may accelerate the wear of the valve core. Avoid introducing impurities such as mud and oil into the water supply pipeline If you find that the water flow becomes smaller or the water does not flow smoothly, you can disassemble the aerator for cleaning. When the temperature is below 0℃ winter, if there is no heating in the installation environment, you need to close the valve and drain the remaining water in the faucet and pipes to prevent the parts from cracking due freezing. Do not disassemble or modify the internal structure of the faucet without authorization, as non-professional maintenance may lead to sealing failure or damage to parts.
4 For daily cleaning, use a soft cotton cloth dipped in neutral cleaner to wipe, then wipe dry with a dry cloth. It is forbidden to use steel wool, abrasive agents or strong acid and alkali cleaners. For stubborn stains on the surface, you can use a soft-bristled brush dipped in a small amount of neutral cleaner to gently scrub avoiding forceful scraping. Water stains on the plating surface must be wiped dry in time to prevent the formation of water scale residue.
Address
Changyang Industrial Zone, Xinqiao Town, Luqiao District, Taizhou City, Zhejiang Province, China
Tel
